The proposed nanosatellite is based on the CubeSat standard, measuring roughly 10 x 10 x 10cm. It will be exposed to extreme space conditions – heat, cold, vacuum and radiation – for an extended period of time.
Dubbed “the first wooden satellite in the world”, the mission was initiated by Jari Makinen, a Finnish writer and broadcaster who has co-founded a company called Arctic Astronautics.
The plywood Wisa Woodsat satellite is due to be launched to space during the “fall of 2021” with a Rocket Lab Electron rocket from the Mahia Peninsula launch complex in New Zealand.
Materials experts at the European Space Agency are contributing a suite of experimental sensors to the mission as well as helping with pre-flight testing, the agency reports.
“It’s been a tight schedule but we welcomed the opportunity to contribute to Woodsat’s payload in return for helping assess its suitability for flight, said Riccardo Rampini, the head of ESA’s Materials’ Physics and Chemistry section. “The first item we’re embarking is a pressure sensor, which will allow us to identify the local pressure in onboard cavities in the hours and days after launch into orbit. This is an important factor for the turn-on of high power systems and radio-frequency antennas, because small amounts of molecules in the cavity can potentially cause them harm.
“This sensor is being built for us by Sens4 in Denmark, who have done a great job to strip down their standard design to fit limited onboard volume and power constraints.”
The world’s first wooden satellite is on the way, in the shape of #Finland’s @wisawoodsat. #ESATech materials experts at #ESTEC in #NL are contributing a suite of experimental sensors to the mission as well as helping with pre-flight testing https://t.co/mm4Ofq8cHw pic.twitter.com/VAEouuYerN
— ESA Technology (@ESA_Tech) June 10, 2021
You can read more about Wisa Woodsat on the WisaPlyWood website. A video of its test stratospheric flight, on 12 June from the Heureka Science Center in Finland, is below.
It is reported that the successful test – of the satellite’s camera and communication equipment – lasted for almost three hours and reached an altitude of 31.2 km.
Introduction Each new generation of computing system always requires higher total power and lower power supply voltage than the previous generation products, so that power supply designers face the problem of maintaining higher output current in a smaller area. Under conditions of high power density and low output voltage, heat dissipation becomes the primary design consideration, especially for l...
“Heart rate is a term used to describe the cardiac cycle. It refers to the number of times the heart beats per minute, subject to the first sound. Heart rate measurement is one of the commonly used medical examination items. Real-time accurate heart rate meas...
“A DBS (Direct Broadcast Satellite) system consists of two main signal processing subsystems, a low noise (LNB) downconverter and a DBS television receiver. The LNB downconverter is located at the base of the satellite dish antenna and is responsible for dow...
“This article introduces how to use a data acquisition system (DAS) composed of delta-sigma analog-to-digital converter (ADC) and ADC to achieve high-performance, high-precision, and wide-range temperature measurement of platinum resistance temperature detect...